CV400-NM-NM-2

CV400-NM-NM-2

Coax cable N Male Clamp + 2m 400_cable + N male Clamp

More details

New

 

Availability: In Stock

Fast shipment
ScontoPrice
Price List--21,84 €
Retail20% 17,47 €
Your price --
Are you an Operator of the Sector?
Request the access to Wholesale price.

17,47 € Your price i.e.

Data sheet

connector "A" typeN male
Cable type4in (10mm)
Cable lenght200
Connector "B" typeN male

More info

Description

High strength and low loss 6GHz Coaxial cable, 1 meter in length, assembled with connectors N male / N male tightened with hardware (Clamped).
Coaxial cables, normally used to connect the access point to the antennas, are a critical component because transferring the RF signal at very high frequencies, up to 5.8 GHz, to the antenna to be radiated on air; if the cable is not well built or is of poor quality, can lead to significant problems.
It 'must use quality cables and Clamped connectors (tightened with hardware), such as cables SELIT CV400-NM-NM-x, in order to minimize potential problems like:
Connection no more reliable after some mechanical stress, especially after a few twists and especially if the connectors are "Crimp type" and not to "Clamp Type" tighten with hardware.
Bad VSWR, stable or intermittent (for false contacts), which can damage the radio card or, worse, de-sensitize his front end.
Cables SELIT CV400-NM-NM-x, are built using low-loss coaxial cable with a diameter of 10mm and N-type male connectors with locking screw to ensure good contact stable over time.
In order to keep the electrical and mechanical caracteristics, we recommend caution in the handling of the cables avoiding excessive twisting, too close bending and, however, all stresses that can alter the concentricity of the cable.
When used in outdoor environment is recommended to cover the connectors with self-vulcanizing tape and good quality isolation tape to ensure a perfect seal against infiltration of water and moisture.
The coaxial cables SELIT CV400-NM-NM-x, handled and installed by following these simple rules, ensuring a transfer of the RF signal from the radio to the antenna with minimum loss and maximum reliability .

Main Features

  • N male Clamp connectors tightened with hardware for high reliability
  • Good VSWR and low Insertion Loss
  • Frequency up to 6GHz
  • 1 meter Lenght

Applications

  • Radio to Antenna RF connection
  • Radio/Splitter and Splitter/Antenna connection
  • General purpose RF connection up to 6GHz

Customers who bought this product also bought:

17 other products in the same category: