KIT AP Hotspot WiFi MiMo Indoor
Kit Bundle to create access points and / or Hotspot WiFi MiMo for indoor use.
The package consists of the following products:
Please note that the KIT is just a group of components useful to make a certain product. The CE certification, where required, it is always and only related to each component of the package (issued by the manufacturer of the component), not to the product resulting from the collection.
The KITs are intended for the exclusive use of professionals who must make all steps to comply the provisions of the R&TTE 99/5/EC Directive (or other legislation in force in the country of use) for the marking (CE, FCC or the one appropriate) of the finished product and to verify its compliance.
StationBox InSpot - Indoor Enclosure for Mikrotik RouterBoards
StationBox® InSpot is indoor enclosure designed for building of wireless hotspots.
StationBox® InSpot directly supports MikroTik RouterBoard RB922, RB912, RB711 and RB411,
also accomodates integrated RB751s and RB951s, all without any tools. InSpot enables installation
on the firm wall or on the ceiling tile.
MIKROTIK RouterBOARD RB912UAG-2HPnD, 2.4GHz 2x2 MIMO, Gbit Eth, RouterOS lvl4, 2x MMCX
The RB912UAG-2HPnD is very versatile device. It's small wireless router with an integrated high power wireless card and an additional miniPCIe slot for 802.11 wireless, or 3G card. The Gigabit port helps to utilize the full potential of 802.11n wireless speeds.
RB912UAG-2HPnD includes RouterOS - the operating system, which can be a router, firewall, bandwidth manager, a CPE and more - all at the same time.
The integrated wireless card is capable of up to 1000mW output power. It has built in 16kV ESD protection on both the Ethernet and the MMCX ports.
|CPU Frequency||600 MHz|
|CPU core number||1|
|Gigabit Ethernet ports||1|
|RAM on board||64 MB|
|Fast Ethernet Ports||NO|
|Integrated wireless card||Yes|
|Wireless standards||802.11 b/g/n|
|PoE in||Yes (Passive Poe)|
|Operating temperature||-40°C +70°C|
|Dimensions||105 x 105 mm|
Pigtail RP-SMA female Bulkhead + 20cm RG316 cable + MMCX male 90°
High resistance and Low loss RF Pigtail assembled with RP-SMA female Bulkhead connector (inner male contact), 20cm RG316/U coax cable and MMCX Male Right Angle connector.
The cable RG316/U double shielded and Teflon dielectric, provides strength, durability and low RF attenuation.
The pigtail is suitable for interconnection of radio cards, wireless LAN equipment and antennas up to 6GHz and higher with minimal signal loss.
|connector "A" type||RPSMA female panel mount|
|Connector "B" type||MMCX|
Omni Antenna for StationBox® 2.4GHz/4dBi rubber duck, UV protected
2.4Ghz omnidirectional antenna from RF Elements.
With its 4dBi gain it is ideal for the StationBox series from RF Elements. Designed for both indoor and outdoor.
RPSMA male connector.
AC/DC Wallmount Switching Converter with POE, Input 100-240Vac, Out 24Vdc 1A
Wallmount Switching Power Supply, Input 100/240Vac Output 12Vdc 1000mA, DC connecotor Plug Jack 5,5mm(outside) x 2,1mm (inner).
|PoE Device Type||Alimentatore PoE|
|Input Voltage||220 V|
|Output Voltage||24 V|
|Output Milli Ampere (mA)||1000|
|Integrated passive PoE injector||Yes|
|Potenza in uscita (W)||24|
|Canali PoE out||1|